Overview

This course will give you a fundamental understanding of drilling and riveting. It will also cover marking fastener locations, setting up the drill motor, drilling pilot holes and enlarging holes, deburring, and driving protruding head rivets.

By the end of this course, you will be able to

• Recognize fastener location and identification information on an engineering drawing
• Mark fastener locations using the calculated fastener location information
• Install a pilot bit in a drill motor
• Create a drill start with a drill motor and pilot bit
• Inspect a full size hole using a Go/NoGo pin gauge
• Use an open countersink and a flat file to deburr holes
• Use a rivet gun and bucking bar to install protruding head rivets
• Inspect the manufactured heads of rivets

Estimated completion time (hours): 4.6